Meyertech ZoneVu 328 Series Technical Information PDF herunterladen (Seite 53)

A&E specification Series 3 Page 7 of 12

The information in this specification is believed to be accurate and reliable. However, no responsibility

or liability is assumed by Meyertech Limited for its use, or for any infringement of patents or other

rights of third parties which may result from its use. No license is granted by implication or otherwise

under any patent or other rights of Meyertech. Meyertech Limited reserve the right to change

specifications without notice.

3.5.3. Video Output Module

The video routing module shall have one hundred and twenty-eight (128) industry standard BNC

connectors to allow the video output to connect to destination equipment.

The nominal impedance of each video output shall by 75R.

A single Power Connector shall be used to provide power to the Video Output Module.

3.5.4. PSU Module

Mains power to the PSU module shall be via a IEC connector.

A plug-socket connector shall be used to distribute DC power to the video matrix modules.

3.6.Configuration

3.6.1. The manufacturer shall provide a system configuration tool that runs on a Windows XP PC platform.

3.6.2. The configuration tool shall permit the setup of all configuration settings of the video matrix.

Configuration by link settings or any other methods will not be permitted.

3.6.3. It is a requirement that ALL video matrix configuration data can be backed-up onto a portable medium

such as CD and restored if required.

3.7.Video Performance

3.7.1. The video matrix shall support fast switching of X-points I.E. a X-point switch will be achieved in under

1µs. Slower methods of switching X-point’s E.G. vertical interval switching will not be accepted.

3.7.2. The video matrix shall have a minimum Bandwidth (–3dB) of 32MHz.

3.7.3. The video matrix shall have a minimum Bandwidth (0.1dB) of 10.5MHz.

3.7.4. The video matrix shall have a minimum Slew rate of 160V/uS.

3.7.5. The video matrix shall have a Differential gain error of < 0.1%.

3.7.6. The video matrix shall have a Differential phase error of < 0.5%

3.7.7. The video matrix shall have a minimum X-talk ( all hostile) @ 6MHz of > -60dB

3.7.8. The video matrix shall have a minimum Output isolation @ 6MHz of > -90dB

3.7.9. The video matrix shall have a minimum Signal to Noise of > -63dB

3.8.Expansion Capabilities

3.8.1. The video matrix controller will be capable of controlling a video matrix of any size (from its minimum

configuration to its maximum configuration) without requiring firmware or software upgrades.

3.8.2. Expansion of video matrix modules shall be achieved through the addition of routing and output cards.

3.8.3. Video inputs shall be expanded in a minimum block size of one hundred and twenty-eight (128)

inputs.

3.8.4. Video outputs shall be expanded in a minimum block size of sixteen (16) outputs.

3.8.5. Expansion of the video matrix system shall be achieved through the addition of video routing and

video output modules and associated PSU modules.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58

Keine Kommentare

Meyertech ZoneVu 328 Series Technical Information Seite 53